gefran 2300 Manual De Uso página 28

tYP.r1 type of linear scale for remote input 1 - see configuration table:
tYP.r1 Function enabled
0 Remote setpoint not enabled
1 0-10V Linear
2 0-20mA Linear
3 4-20mA Linear
+4 Set relative to local set; the set is the
algebric sum of remote set 1 and
trip point 1
tYP.r2 type of linear scale for remote input 2 - see configuration table:
tYP.r2 Function enabled
0 Remote setpoint not enabled
1 0-10V Linear
2 0-20mA Linear
3 4-20mA Linear
+4 Set relative to local set; the set is the
algebric sum of remote set 2 and
trip point 2
The enabled remote input (code other than 0) is read with simultaneous flashing of the OUT2 and REM LEDs.
Lo.SP lower limit for setpoints (locals or remotes) in scale range -1999/+9999 (may be higher than Hi.SP).(*)
Hi.SP upper limit for setpoints (locals or remotes) in scale range 1999/+9999 (may be lower than Lo.SP).(*)
out_tr type of signal in output W (analog retransmission) according to table:
RETRANSMITTED VARIABLE
0 Input (displayed value)
1 Peak + (maximum)
2 Peak - (minimum)
3 Peak - peak
4 Trip point 1
5 Trip point 2
6 Trip point 3
7 Trip point 4
8 Trip point 5
9 Trip point 6
10 Trip point 7
11 Trip point 8
12 Trip point 9
13 Trip point 10
14 Remote setpoint 1
15 Remote setpoint 2
64 Main input value in case of
process variable with
inputs sum function
65 GROSS value
66 TARE value (Zero)
67 Value managed directly from serial line
(CENCAL only) in scale points
Nota: Add +16 to code 0-15 to obtain output type 2-10V or 4-20mA
Add +32 to selected code to enable management of the output during alarm setpoint setting phase (function enabled
only for codes (4....13).
8 • CONFIGURATIONS
SIGNAL TYPE
0-10V or 0-20mA
28