Craftmade WXL52AG Guia De Instalacion página 6

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

5. Fan Assembly. (cont.)
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of
electrical tape to the ends of the electrical
wires--this will keep the wires together when
threading them through the downrod.
Locate canopy cover in hardware pack. Loosen
yoke set screws and nuts at top of downrod
support. Remove pin and clip from downrod
support. Slide downrod through canopy,
canopy cover and yoke cover. [Note: Canopy
cover must be turned with shiny side toward
the motor.]
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the
upper end of the downrod.
Thread downrod into top of downrod support
until holes for pin and clip in downrod align
with holes in yoke--make sure wires do not get
twisted. Re-insert pin and clip that were
previously removed. Tighten yoke set screws
and nut securely. Lower yoke cover to
downrod support.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and
instructions appearing in the manual are not
meant to cover all possible conditions and
situations that may occur. It must be understood
that common sense and caution are necessary
factors in the installation and operation of this
fan.
electrical wiring
canopy
yoke cover
clip
page 5
safety cable
downrod
canopy cover
yoke set screw
and nut
pin
downrod support
motor
housing

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Wxl52fwWxl52ts

Tabla de contenido