Connections; Determination Of The Flow Rate, The Pipe Diameter, And The Pressure Loss - GOK GS Pro-Fi 3 Instrucciones Par El Montaje Y El Funcionamiento

CONNECTIONS

Inlet,
optional
Outlet,
optional
DETERMINATION OF THE FLOW RATE, THE PIPE DIAMETER, AND THE PRESSURE
LOSS
Flow rate
The outlet pipe must be dimensioned pursuant to DIN 4755 in such a way that the mean flow
rate of the fuel oil is between (0.2 and 0.5) m/s. In the event of too large a pipe diameter with
low flow rates, undesired formation of gas bubbles may occur.
Determination of the flow rate w in m/s
⇒
Installation in
.
V
=
Volume flow rate
Operating medium
(L/h)
For supply / oil systems, the following mean flow rate is applicable pursuant to DIN
4755:
Taking into account the length of the suction
line, the geodesic height, the suction height,
and the fuel oil volume flow rate, the following
can be recommended for selecting the piping:
• Lower flow rates in suction mode will result in an undesired formation of bubbles.
• Piping with inner diameters of less than 4mm is not recommended!
Maximum total pressure loss of all fittings in the suction line = 0.4bar
Item No. 13 512 53
Combined heating oil filter breather type GS Pro-Fi
Trading name and dimensions
acc. to standard
screw-in fitting
• IG G 3/8
For accepting a screw-in fitting with O-ring
• compression fitting RVS
• compr. fit. 6
Trading name and dimensions
acc. to standard
ball-cone connector
• thread AG G 3/8-KN
Single string
system
≈
Heat input
in kW / 10
Suction: (0.2 ÷ 0.5) m/s
Double string
system
=
Gear output of the
Oil burner pump
.
V Fuel oil
1 ÷ 10L/h
8 ÷ 45L/h
25 ÷ 130L/h
⇒
90 ÷ 170L/h
Installation notes
Installation notes
torque 15Nm
Conveyor Calculation
system
=
w = 0.3537 •
Delivery rate
ID=inner pipe
of the booster
diameter (mm)
pump
Discharge: (1.0 ÷1.5) m/s
∅ x t
Copper pipe
6 x 1mm
8 x 1mm
10 x 1mm
12 x 1mm
®
3
.
2
/ ID
V
5 / 16