This appliance is factory
preset for propane gas. No
changes are required for
connecting to propane. Only
a qualified installer or service
technician can perform gas selec-
tion and connecting to gas supply.
CAUTION: Two gas line in-
stallations at the same time are
prohibited.
CAUTION: To avoid gas leak-
age for the gas not being used at
the inlet of regulator, a qualified
installer or service technician
must use supplied cap.
You will notice a color coded
plunger on the inside of the
regulator. This is normal. When
the inlet connection fitting is
inserted and tightened, this
plunger will be pushed back
by the fitting making all of the
adjustments for the gas being
supplied. DO NOT REMOVE THE
PLUNGER. The regulator will
not work and the warranty will
be voided.
The inlet regulator is color coded
for identification of the correct
gas type. Blue is for propane (LP
gas) and yellow is for natural gas.
10
INSTALLATION
GAS SELECTION
Insert Gas Fitting
for Propane Gas
Blue Propane
Gas Plunger
Underneath Dust
Cover
Apply thread sealant to the threads on the
connection fitting. While pushing in, rotate
the fitting clockwise until the threads engage
the regulator. After the fitting has been hand
tightened into the regulator use a wrench to
complete tightening of the fitting. Install ad-
ditional fitting to connect to the house supply.
www.sureheat.com
Yellow Natural Gas
Plunger Underneath
Metal Cap
Figure 5 - Gas Regulator
FOR PROPANE GAS
INSTALLATION: BLUE
DO NOT REMOVE
Blue Propane Plunger
Install Gas Fitting Here
Insert Gas Fitting
for Natural Gas
200176-01B