3
Inspection, points to verify
Before each use
Harness
Check the webbing at the attachment points, at the adjustment
buckles and at the safety stitching.
Look for cuts in the webbing, wear and damage due to use, to
heat, and to contact with chemical products, etc. Be particularly
careful to check for cut threads.
Verify that the DoubleBack and FAST buckles operate properly.
Check the fall arrest indicator. The indicator shows red if the
dorsal attachment point sustains a shock-load greater than
400 daN. Do not use the harness anymore if the fall arrest
indicator is visible.
Front connector/buckle
Make sure the frame, gate, and locking sleeve are free of any
cracks, deformation, corrosion, etc. Open the gate and verify
that it closes and locks itself automatically when released. The
Keylock slot must not be blocked by any foreign matter (dirt,
pebble, etc.).
During each use
It is important to regularly inspect the condition of the product.
Make sure that all pieces of equipment in your system are
correctly connected and positioned with respect to each other.
Consult the details of the inspection procedure to be carried
out for each type of PPE on the Web at www.petzl.com/ppe or
on the PETZL PPE CD-ROM.
Contact PETZL if there is any doubt about the condition of this
product.
5
How to put the harness on
Open the buckles on the leg loops.
5B. Adjust the waistbelt by pulling
5A. Putting the
on the waist-belt straps. Stow the
shoulder straps off
excess webbing neatly (flat - no
to one side, hold
loops of slack) using the strap
the seat harness by
retainers.
the waistbelt and
slip it on over your
legs.
5A.
5B.
- Short ends: use the
retainers in front of the
adjustment buckles.
- Long ends: pass them
through the lateral
rings then through the
retainers behind the
rings.
3
NAVAHO BOD C71000 B / NAVAHO BOD FAST C710F0 B / NAVAHO BOD FAST NOIR C710FN B
4
Compatibility
WARNING, when using multiple pieces of
equipment together, a dangerous situation
can result if the safety function of one
piece of equipment is compromised
by the operation of another piece of
equipment.
An incompatible connection can cause
accidental disconnection, breakage, or
affect the safety function of another piece
of equipment.
Any equipment attached to your
harness (anchors, locking connectors,
absorbers etc.) must conform to current
standards.
Contact Petzl if you are uncertain about
the compatibility of your equipment.
5C. Fasten and adjust the leg loops.
- NAVAHO BOD: DoubleBack buckles.
- NAVAHO BOD FAST: Fasten the FAST
buckles. Be careful of foreign bodies which
can impede the operation of the FAST
buckles (pebbles, sand, clothing...). Verify
that the buckles are correctly fastened.
5C.
DoubleBack
DoubleBack
Fast
C715000C (060112)
Fast
Go to size 2
