Removing The Unit; Din Rear-Mount (Method B) - Lenco CS-321 Manual Del Usaurio

INSTALLATION
screwdriver. Not all tabs will be able to
make contact, so examine which ones
will be most effective. Bending open the
appropriate tabs behind the dashboard
to secure the sleeve in place.
Screwdriver
6.connect the wire harness and the
antenna and be careful not to pinch any
wires or cables.
7.ide the unit into the sleeve until it locks
into place.
8. further secure the unit, use the supplied
metal strap to secure the back of the unit
in place. Use the supplied hardware
(Hex Nut (M5mm) and Spring Washer) to
attach one end of the strap to the
mounting bolt on the back of the unit. If
necessary, bend the metal strap
to fit your vehicle's mounting area. Then
use the supplied hardware (Tapping
Screw (5x25mm) and Plain Washer) to
attach the other end of metal strap to a
solid metal part of the vehicle under the
dashboard. This strap also helps ensure
proper electrical grounding of the unit.
Note to install the short threading
terminal of the mounting bolt to the back
of the unit and the other long threading
terminal to the dashboard.
Dashboard
Tabs
Sleeve
Mounting Bolt
9.econnect the cable to the vehicle
battery's negative (-) terminal. Then
replace the outer trim ring.

Removing the unit

1.e sure the ignition is turned off, then
disconnect the cable from the vehicle
battery's negative (-) terminal.
2.move the metal strap attached the back
of the unit (if attached).
3.ft the top of the outer trim ring then pull it
out to remove it.
4.sert both of the supplied keys into the
slots at the middle left and right sides of
the unit, then pull the unit out of the
dashboard.

DIN REAR-MOUNT (Method B)

If your vehicle is a Nissan, Toyota, follow
these mounting instructions.
Use the screw holes marked T (Toyota), N
(Nissan) located on both sides of the unit to
fasten the unit to the factory radio mounting
brackets supplied with your vehicle.
18
Spring Washer Hex Nut
Metal Strap
Plain Washer
Tapping Screw