Application
Operation is possible in conjunction with:
- Pressurized storage heaters
Operation is not possible with:
- Low-pressure storage heaters (displacement water heaters)
Technical data
• Max. flow
• Flow pressure
- min.
- recommended
- greater than 72.5 psi, fit with pressure reducing valves
• Max. operating pressure
• Test pressure
• Temperature
- max. (hot water inlet)
• Water connection
Notes
• Installation of backflow protection must comply with local codes
and regulations.
• Major pressure differences between cold and hot water supply
should be avoided.
1
3
13 L/min or 3.4 gpm/45 psi
14.5 - 72.5 psi
cold - Right hand
hot - Left hand
A
32mm
24mm
C
English
Installation
, see dimensional drawing on page 1.
Flush piping system prior and after installation of faucet
thoroughly!
Side valves, see fig. [1].
• Valve with a groove on the top edge of the cartridge (A) and in
addition marked with COLD should be mounted on the right (cold
water) side.
• Valve without a groove on the top edge of the cartridge (A) and in
addition marked with HOT should be mounted on the left (hot
7.25 psi
water) side.
1. Screw the mounting set (B) to the bottom of the thread of the
side valve (C).
145 psi
Make sure that the rubber washer (B1) is on the top of the fiber
232 psi
washer (B2).
2. Insert the side valve (C) through the basin hole from below.
176 °F
3. Close the cartridges (clockwise for the hot side and counter-
clockwise for the cold side).
4. Place the escutcheon O-ring (D1) on the basin and screw down
the escutcheon (D) until it stops.
5. Tighten the mounting set (B) from below to secure the valve.
6. Install the lever (E) to the stem of the cartridge (A) and be sure
that the lever points away from the spout.
E
D
D1
B1
B2
B
