Unpacking; Assembly - JET J-F225 Instrucciones De Funcionamiento Y Manual De Piezas

Unpacking

Remove packing and two
containing the handle and workstop, requiring
simple assembly, from shipping container. Then lift
machine from container and place on sturdy work
surface.

Assembly

Handgrip
Tools required
23mm wrench
Crosspoint screwdriver
Referring to Figure 3:
1. Screw the threaded end (D) of the operating
handle into the threaded opening (E) of the
crank case. Back off slightly, aligning the
position of the trigger handle (A) for a
comfortable grip when operator stands before
the machine.
2. Secure the operating handle (B) by tightening
the lock nut (C) with a 23mm wrench.
3. Attach the connector (F) of the cable to the
socket (G) on the side of the switchbox.
4. Attach the cable cover (H) to the crank-
case (K). Secure the cover with four M4x6 pan
head screws (J).
Tighten with a crosspoint screwdriver. Make
sure the cable can move freely inside the
cover and is not pinched between the cover
base and crankcase.
Work Stop
Tools required
adjustable wrench
Referring to Figure 4, assemble the workstop as
follows:
1. Loosen the lock knob (A) on the stock stop (B)
and slide it onto the stop bar (C).
2. Thread the assembly (D) into the mounting
bracket (E). Place an adjustable wrench at the
indents (F) and tighten the rod.
wrapped parcels
8
Figure 3
Figure 4