Controls; Operation - JET J-F225 Instrucciones De Funcionamiento Y Manual De Piezas

Controls

Power Switch – The power switch has two
positions, off and on. To operate the machine, the
Power switch must be set to on. Then depress
micro-switch (Figure 8) in the trigger handle to
start.
Locking Key – When the saw is not in use, the
switch should be locked in the off position. To lock
the switch in the off position, pull out the safety key
(Figure 7). The saw will not start with the key
removed. However, if the key is removed while the
switch is in the on position, it can be turned off
once. The saw will not restart until the key has
been reinserted into the switch.
Trigger Handle – To operate, the On/Off switch
must be set to on and the microswitch on the
trigger handle (Figure 8) depressed.

Operation

Before using the machine:
1. Check that safety devices (ex., blade guards)
are in position and work perfectly and that
personal safety requirements are complied
with.
2. Check the sharpness of the blade and verify
coolant flow.
To operate:
3. Make sure the work piece is securely clamped
in the vise.
4. Turn the power on (Figure 7).
5. Grip the trigger handle (Figure 8) on the control
lever.
6. Start the blade by pressing the micro-switch on
the handgrip.
The down stroke speed of the head is controlled
manually by the operator.
When the cut is complete:
7. Raise the head.
8. Remove the work piece from the vise using the
vise hand wheels.
12
Figure 7
Figure 8