RealFlame 310 Manual De Instrucciones página 4

Step Two
After opening Real Flame® Gel Fuel cans, place
one can into each slot in the Base (1).
Place the Top Log (2) with the attached Plate
(3) onto the Base (1). (Fig. 2) The plate should
be in contact with the gel fuel cans with tabs
resting on the rims of the cans.
If the plate is not sitting on the cans, add
another Washer (6) between the Top Log (2)
and the Plate (3). If necessary, repeat this step
to acheive the correct fit.
Step Three
Light the gel fuel cans with an extended
lighter or match.
WARNING
Do not touch the logs or the metal plate
during or after burning gel fuel. They will
be HOT! Allow surfaces to cool for at
least 20 minutes before touching,
changing the cans or moving the log set.
INSTRUCTIONS
1
Figure 2
4
Figure 3
3
2