Access Codes; Setting The Parameters - HUEGLI TECH HT DST4602 Manual De Uso

4.7.1.1

Access codes

Information!: If the password is lost, you can reconfigure it using a higher level password. Contact
our service centre if the "MANUFACTURER" password is lost.
Access to the programming mode can be controlled by 4 different PASSWORD levels, which are listed in order of
priority.
1.
2.
3.
4.
In the first page (000-Access Code) of the SYSTEM menu, will ask you for the access code if one or more
passwords have been assigned.
If a password is set to 0, it is not assigned and not required.
The USER can only display and change the User Password.
The INSTALLER can change the User Password and the Installer Password.
The MANUFACTURER can display and change all three passwords.
SICES can
the plant parallel function.
The Password setting pages are displayed in the SYSTEM submenu, if the user is authorised to change the
settings.
In programming mode, if the page for changing the password isn't displayed when the Password is entered, press
EXIT to return to the previous menu and try opening the page again.
The set access code remains in the memory for about 10 minutes after programming has been completed. After
that it must be entered again to access the programming mode.
4.7.1.2

Setting the parameters

Enable the mode with the ENTER
Use the UP
Select the variable or submenu with the UP
Pressing ENTER
The value of the variable is displayed in square brackets, for example: [400]
To change the variable, press ENTER
UP and DOWN
to abort.
To change the variables, the lockable selector must be OFF. Some variables can only be changed with the
lockable selector in another position other than OFF.
If you cannot change a variable in any condition, this is shown as follows:<400> showing that the parameter
cannot be changed in this status.
To exit the programming menu, use the EXIT
SICES password
Manufacturer password
Installer password
User password
display and change
button.
and DOWN buttons to select a menu and the ENTER
when there are no submenus, displays the page of variables for the menu entry.
; the square brackets [ ] will flash. Use the
buttons to change the value and press ENTER
some critical parameters
buttons.
and DOWN .
button.
for configuring
button to open the same.
to confirm or EXIT
User's Manual HT DST4602
13