Description Of The Hood & Controls; Controls; Maintenance; Cleaning - ELICA CERVINA Guía De Instalación, Uso Y Mantenimiento

Description of the hood
& Controls
3
4
1. Blower control switch
2. Light control switch
3. Lamp housings
4. Grease filter Handle

5. Grease filter

Controls

Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Description of control panel
1
1. Light Control
• Turn the light control from OFF to HI for the brightest
light while cooking.
2. Fan Control
• Turn the fan control speed from OFF to HI as
needed.

Maintenance

ATTENTION! Before performing any maintenance operation, isolate
the hood from the electrical supply by switching off at the connector
and removing the connector fuse.
Or if the appliance has been connected through a plug and socket,
then the plug must be removed from the socket.
2
1
5
2
9

Cleaning

Do not spray cleaners directly to the control while
cleaning the Hood.The cooker hood should be cleaned
regularly (at least with the same frequency with which you
carry out maintenance of the fat filters) internally and
externally. Clean using the cloth dampened with neutral
liquid detergent. Do not use abrasive products. DO NOT
USE ALCOHOL!
WARNING:
Failure to carry out the basic cleaning recommendations of
the cooker hood and replacement of the filters may cause
fire risks.
Therefore, we recommend oserving these instructions.
The manufacturer declines all responsibility for any damage
to the motor or any fire damage linked to inappropriate
maintenance or failure to observe the above safety
recommendations.
Grease Filter
To Remove Metal Grease Filters:
• Use 2 hands to remove the metal grease filters. Grasp filter
handles, push toward the rear of the range hood and pull
down on the front handle to remove.
• Repeat for each grease filter.
• Wash metal grease filters as needed in a dishwasher or
hand wash in a hot detergent solution to clean.
To Reinstall Metal Grease Filters:
• Grasp filter handles and place rear of filter into rear track.
• Push down on the rear handle and set the front of the grease
filter into the front track to secure.
• Repeat for each filter.

Replacing the light bulb

CAUTION
Before replacing the lamps, switch power off at service
panel and lock service panel disconnecting means to
prevent power from being switched on accidentally.
NOTE: Turn off the lights and fan. Allow the lights to
cool before handling. If new lights do not operate be
sure lights are inserted correctly before calling service.
Replace Lights
• Remove the damaged light (twist
and replace with a new 120 Volt, 50 Watt (maximum)
50° halogen light made for a GU10 base, suitable for
use in open luminarie.
2
1
counter clockwise)