Tabla de contenido
ZF
x 4
ZL
x 5
FIG. 14
14) Lay the Top (W) over the apron/leg assembly so that the cam connectors go through the holes
in the top edge of the aprons. Fasten in place with 3/4" and 1/2" Cam Housings (ZL &ZF).
See FIGURE 14.
ZY
x 3
YB
x 2
FIG. 15
15) The rack may be attached at any height. Slide rack assembly between the legs to desired height.
Make sure that the rack is level, fasten the right rack support to the right legs with #7 x 1½" Type
17 Pan Head Screws (YB) through the pocket drilled holes in bottom edge of right rack support.
Fasten on the left side to vertical divider with three #6 x 1" Oval Head Screws (ZY) through the
countersunk holes in Left Rack Support. See FIGURE 15.
Page 12 — 140W
Tabla de contenido
