Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Move the Refrigerator Drawers to
Final Location
IMPORTANT:
To avoid floor damage, make sure the levelers are raised (not
touching floor) and the weight of the appliance is on the
rollers before moving.
Rollers are for moving the refrigerator drawers and not for
permanent support.
1. Place top of cardboard carton or plywood under the
appliance. Remove dolly.
2. Do not remove protective film or cover.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
3. Plug into a grounded 3 prong outlet.
4. Move the refrigerator drawers straight back and evenly in
front of the opening.
Lower the Leveling Legs
IMPORTANT:
All four leveling legs must contact the floor to support and
stabilize the full weight of the refrigerator drawers.
Rollers are for moving the refrigerator drawers and not for
permanent support.
To avoid cabinet/countertop damage, do not apply more than
50 inch–pounds (58 cm - kg) of torque to the leveling legs.
When leveling, be sure that the gap between the upper
drawer and the bottom edge of the countertop is a minimum
of ³⁄₈" (9.5 mm).
Style 2: Overlay—Be sure to install the custom overlay drawer
panels before leveling the refrigerator drawers. See "Style 2:
Install Custom Overlay Drawer Panels."
10
1. Using a ⁵⁄₁₆" socket wrench (and extension if necessary), turn
the leveling bolts on both sides of the refrigerator drawers to
the right (clockwise) until the leveling legs support the
refrigerator drawers' weight.
A
A. Rear leveling bolt
B. Front leveling bolt
2. Lower all four leveling legs until the refrigerator drawers are
the proper height.
Level the Refrigerator Drawers
IMPORTANT:
Style 2–Overlay: Be sure to install the custom overlay drawer
panels before leveling the refrigerator drawers for the Overlay
Model. See "Style 2: Install Custom Overlay Drawer Panels."
Before installing the refrigerator drawers, be sure that the
countertop is level.
If the countertop is not level, adjust the refrigerator drawers'
front and rear leveling bolts until the appliance is square with
the countertop. Be sure to maintain ³⁄₈" (9.5 mm) minimum
gap between the top of the drawer and the countertop.
1. Open the top drawer and place the level across the top
drawer as shown. Check the level from left to right.
A
A. Check the level from left to right.
2. Using the front and rear leveling bolts, adjust the refrigerator
drawers cabinet until the top drawer measures level from left
to right. See "Lower Leveling Legs."
NOTE: Adjusting the front and rear leveling bolts together will
either raise or lower the side of the refrigerator drawers
cabinet.
3. Remove the level and close the top drawer. Check the gap
between the top of the drawer and the countertop. If the gap
measures less than ³⁄₈" (9.5 mm) minimum, turn all four
leveling bolts equally to the left to raise the leveling legs (this
will lower the appliance). Recheck the level.
B
A
Tabla de contenido
