Troubleshooting - Klarstein 10028189 Manual De Usuario

Problems
The air conditioning does not
work.
The cooling effect is not good.
Big Noise
The compressor does not work. Overheat protection starts.
The remote control does not
work.
Displays ‚E1'.
Displays ‚E2'
21

Troubleshooting

Reasons
There is no electricity.
The overflow indicator displays
„FL".
The ambient temperature is too
low or too high.
In cooling mode, the room
temperature is lower than the set
temperature.
In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open;
there are a lot of people; or in
cooling mode, there are other
sources of heat.
The filter screen is dirty.
The air inlet or outlet is blocked.
The air conditioning is not placed
on a flat surface.
The distance between the
machine and the remote control
is too far.
The remote control is not aligned
with the direction of the remote
control receiver.
Batteries are dead.
The pipe temperature sensor is
abnormal.
The room temperature sensor is
abnormal.
Solutions
Turn it on after connecting it to a
socket with electricity.
Discharge the water inside.
in at the temperature of 7-35 ℃
Recommend to use the machine
(44-95 ℉).
Change the set temperature.
The machine is placed in a room
greater than 17 ℃ (62 ℉).
with an ambient temperature of
Pull the curtains.
Close doors and windows, and
add new air conditioning.
Clean or replace the filter screen.
Clear obstructions.
Put the air conditioning on a flat
and hard place (to reduce noise).
Wait for 3 minutes until the
temperature is lowered, and then
restart the machine.
Let the remote control get close
to the air conditioning, and make
sure that the remote control
directly faces to the direction of
the remote control receiver.
Replace batteries.
Check the pipe temperature
sensor and related circuitry.
Check the room temperature
sensor and related circuitry.