Kenmore 95683 Manual De Uso Y Cuidado página 5

Door Reversal
CAUTION : To avoid injury to yourself and/or property, we recommend
someone assist you during the door reversal process.
1,To access lower hinge, tilt back the refrigerator cabinet (Avoid
tilting the refrigerator 45 degrees).
2, Remove left adjustable leg located at the front of the cabinet
(Fig.A).
3, Remove the screws holding the lower hinge to the cabinet
(Fig.A).
4, Remove the lower door from the refrigerator cabinet (open
door and pull down).
5, Remove the screws from the middle hinge, then remove the
middle hinge and upper door (open door and pull down).
6, Remove the upper hinge (Fig.C).
NOTE: Be careful to retain all gaskets and washers in
position when removing and reinstalling hinges.
7,,Re-install the upper hinge on the opposite side of the cabinet
(Fig.C).
8, Remove the door plugs located on the top of each door.
9, Re-fit the door plugs on the opposite sides of both doors.
10, Re-install the upper door on cabinet
11,Remove the middle hinge plugs from the divider panel
between the upper and lower compartment (Fig.B).
Re-fit plugs on opposite side of panel. Re-install middle hinge
using holes exposed from removal of plugs.
12, Re-install the lower door on cabinet.
13, Re-install the lower hinge on the opposite side of cabinet base.
14, Re-install the adjustable leg to the opposite side of cabinet.
15, Make sure the doors are properly aligned on the cabinet before
tightening the screws.
The process is now complete.
8
Initial Use
To reach the set coldness level when operating the refrigerator for the first time, run it without food
load until you hear the compressor stop. This usually takes 2 to 3 hours. Once the set temperature is
reached, load food into the refrigerator.
Note: If the refrigerator has been placed in a horizontal or
tilted position for any period of time, wait 24 hours before plugging it in.
Temperature Control
The first time you turn the unit on, adjust the temperature control knob to 3 and
give your refrigerator time to cool down completely before adding food; a full OFF
Cod_, .... . Cdd
24 hours is recommended. After it is fully cooled, test it and adjust towards 1to /'_ _,
make less cool or towards 6 to cool more to best suit your needs. _/ _ ,Jo
Note: Turning the temperature control knob to the OFF position will stop the
cooling cycle but does not shut off power to the unit.
Defrosting Your Refrigerator
For maximum energy efficiency, defrost freezer section whenever frost accumulates to a thickness of
1/8" or more on freezer watts. Note that frost tends to accumulate more during the summer months.
To defrost freezer, remove food and ice cube tray from the freezer section. To defrost, turn the
temperature control dial to the "Off" position.
Defrosting may take a few hours. To speed up defrost time, keep the door open and place a bowl
of warm water in the refrigerator.
You may now reset your refrigerator to the desired temperature and return food.
ii
iii
Normal Operating Sounds You May Hear
Boiling water, gurgting sounds or slight vibrations that are the result of the refrigerant
circulating through the cooling colts.
The thermostat control will click when it cycles on and off.
6/8/10