Tabla de contenido
Idiomas disponibles
Idiomas disponibles
sectioN 5
5.0
replacement parts
5.1
general
Always provide the serial number of the unit on which the torch will be used. The serial number is stamped on
the unit nameplate.
5.2
ordering
To ensure proper operation, it is recommended that only genuine Prest-O-Lite parts and products be used with
this equipment. The use of non Prest-O-Lite parts may void your warranty.
Replacement parts may be ordered from your Prest-O-Lite Distributor.
Be sure to indicate any special shipping instructions when ordering replacement parts.
Refer to the Communications Guide located on the back page of this manual for a list of customer service phone
numbers.
Bill of material items that have blank part numbers are provided for customer information only.
5.3
Definitions
"xt" consumables - Used with currently produced product - Prest-O-Lite 80 and Prest-O-Lite 550.
high performance Nozzle - Gives maximum cutting thickness and speed capability.
extended life Nozzle - Gives extended nozzle life at the expense of top end cutting thickness and speed capability.
5.4
pt-31xl and pt-31xlpc replacement parts
1.
The PT-1 torch is used on several different cutting packages which require different torch trigger connection configu-
rations as shown in Figure 5-1, 5- and Table 5-1.
.
The PT-1 torch is adaptable to standard, heavy duty or XT consumables to meet specific cutting applications. See
Subsections 5.4.1, 5.4. and 5.4..
.
Individual consumable parts can be ordered as needed if spare parts kits do not fit current needs.
In most cases, it is recommended that you order the same consumable parts that were shipped with your plasma cutting
system.
Hardware items should be available through local sources.
Note
5
replacemeNt parts
Tabla de contenido
