Poulan PL914 Manual De Instrucciones página 10

BEFORE STARTING
• Make sure you have the proper personal protective
equipment.
• Inspect the cleanliness of the power tool. Make sure the
handles are dry, clean, and free of oil and grease.
• Inspect for correct alignment of moving parts.
• Inspect for broken or damaged parts. Do not use the
power tool if any damage affects safety or operation.
Have damage repaired by an authorized service center.
• Inspect the chain. Keep the chain sharp, clean,
lubricated and properly tensioned for better and safer
performance.
• Inspect all screws and nuts. Tighten if necessary.
• Inspect the power cord. If it is damaged, have it repaired
by an authorized service center.
• Inspect the extension cord. Replace it if it is damaged.
• Check the oil level gauge prior to starting and regularly
• Connect the power cord to the extension cord.
• Connect the extension cord to the power supply.
To reduce the risk of disconnection of power cord from
the extension cord during operating, make a knot as
illustrated, then connect the extension cord plug to the
outlet.
A cable hook (12) is attached to the handle to reduce
strain on the extension cord. To use the cable hook, insert
the extension cord into the hole at the rear of the chain
saw. Place the loop formed over the cable hook. Gently
tug on the extension cord to ensure that it is tightened
around the cable hook.
Keep the extension cord clear of the work area. Position
the cord so that it will not get caught on bushes, hedges,
tree trunks, or other obstructions while you are working.
10
OPERATION
a WARNING: Check the extension cord before each
replace immediately. Never use the tool with a
damaged cord since touching the damaged area
could cause electrical shock, resulting in serious
injury.
PERSONAL PROTECTIVE EQUIPMENT
A. Use eye protection such as non-fogging, vented
goggles or a face screen.
protect your hearing.
C. Use an approved safety hard hat.
E. Use heavy-duty, non-slip gloves.
F. Use safety chaps.
G. Use steel-toed safety footwear with non-slip soles.
STARTING AND STOPPING THE CHAINSAW
To start the chain saw:
Press and hold the trigger lock (11). This makes the trigger
operational.
Squeeze and hold the trigger (13), release the trigger
lock, and continue to squeeze the trigger for continued
operation.
After starting the chain saw, it will run immediately at high
speed.
To stop the chain saw:
Release the trigger.
Releasing the trigger stops the chain saw within 1 second.
Heavy sparking is normal. If releasing the trigger does
not stop chain saw within 1 second, have the machine
serviced by an authorized service center.
In the event of kick-back, the chain brake (3) will be
actuated via the front hand guard. The front hand guard is
pushed forwards by the back of the hand and this causes
the chain brake to stop the motor within 0.15 seconds.
To be able to use the chain saw again, you must release
the chain brake. Switch off the chain saw, then push the
front hand guard back into the vertical position until it locks
in place. The chain brake is now fully functional again.
Check the operating condition of the chain brake prior to
each use.
Engage the chain brake by rotating your left hand around
the front handle, allowing the back of your hand to push
the front hand guard toward the bar while the chain is
rotating rapidly. Be sure to maintain both hands on the
saw handles at all times.
Release the chain brake by grasping the top of the front
hand guard and pulling toward the front handle.
C
B
A
D
F
G
E