Attaching The Projector Plate - KlipXtreme KPM-590B Manual Del Usaurio

Attaching the projector plate

Step 1
- This projector mount comes with two additional adjustable legs. If the short-preinstalled legs are
not long enough, you can swap them out with the longer extension legs.
- Place the projector plate in the center of the projector and locate the projector's mounting points at
each corner of the device. All mounting points might not be used on certain projectors.
- Slightly adjust the projector plate's adjustable legs to t into the projector holes.
- Use the corresponding washers and screws to x the projector plate in place.
Note: All four legs may not be needed for certain projectors.
Attaching the projector plate to the ceiling plate
- Once both plates are securely adjusted connect both parts by sliding the projector plate into the tilt
assembly and adjust with the corresponding bolts.
- You can adjust the tilt and swivel angles.
- Once it is in your desired position, tighten all bolts.
On the ceiling
On the wall