Replacement Parts; Service And Repairs - Porter & Cable PCE210 Manual De Instrucciones

Llave de impacto con yunque de anillo del cerdo de 13mm (1/2 pul)
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

• Material: The type of material and
surface finish of the material will affect
fastening torque.
• fastening Time: Longer fastening time
results in increased fastening torque.
Using a longer fastening time than
recommended could cause the fasteners
to be overstressed, stripped or damaged.
capacity
Your 1/2" (12.7 mm) impact wrench uses
sockets with 1/2" (12.7 mm) square drive ends.
Maintenance
WaRNiNG:
To reduce the risk of
Injury, turn unit off and disconnect it
from power source before installing
and removing accessories, before
adjusting or when making repairs. An
accidental start-up can cause injury.
cleaning
WaRNiNG:
Blow dirt and dust out of
all air vents with clearn, dry air at least
once a week. To minimze the risk of eye
injury, always wear ANSI Z87.1 approved
eye protection when performing this.
WaRNiNG:
Never use solvents or
other harsh chemicals for clearning the non-
metallic parts of the tool. These chemicals
may weaken the plastic materials used in
these parts. Use a cloth dampened only
with water and mild soap. Never let any
liquid get inside the tool; never immerse any
part of the tool into a liquid.

Replacement Parts

Use only identical replacement parts.
For a parts list or to order parts, visit our
service website at www.portercable.com.
You can also order parts from your nearest
PORTER-CABLE Factory Service Center
or PORTER-CABLE Authorized Warranty
Service Center. Or, you can call our
Customer Care Center at (888) 848-5175.
This Class B digital apparatus complies
with Canadian ICES-003.
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
NoTe: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.
If this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications to this unit
not expressly approved by the party
responsible for compliance could void the
user's authority to operate the equipment.
This Class B digital apparatus complies
with Canadian ICES-003.

Service and Repairs

All quality tools will eventually require
servicing and/or replacement of parts.
For information about PORTER-CABLE,
its factory service centers or authorized
warranty service centers, visit our website
at www.portercable.com or call our
Customer Care Center at (888) 848-5175.
All repairs made by our service centers are
fully guaranteed against defective material
and workmanship. We cannot guarantee
repairs made or attempted by others.
You can also write to us for information at
PORTER-CABLE, 4825 Highway 45 North,
Jackson, Tennessee 38305, (888) 848-
5175 - Attention: Product Service. Be sure
to include all of the information shown on
the nameplate of your tool (model number,
type, serial number, etc.).
Accessories
WARNING
than those offered by PORTER-CABLE,
have not been tested with this product,
use of such accessories with this tool
could be hazardous. To reduce the risk of
injury, only PORTER-CABLE
recommended accessories should be
used with this product.
A complete line of accessories is
available from your PORTER-CABLE
Factory Service Center or a PORTER-
6
:
Since accessories, other
Tabla de contenido
loading

Tabla de contenido