Emergency Mode - eTIGER S4 Combo Secual Manual Del Usario

Arm the System
Press the Arm button " " on the control
panel. The control panel beeps once: the
system is armed.
Note
If the Entry / Exit Delay is activated, only the
Delay zone will be armed after the delay set
(refer to the instructions on page 11 of this
manual "Entry / Exit Delay").
Disarm the System
Type your user code and press the Disarm
button " " on the control panel. The control
panel beeps twice: the system is disarmed.
Default user code: 1234
Home Mode
Press the Stay button " " on the control
panel. The control panel beeps once: the
system is armed in Home Mode.
All the sensors assigned to the Normal zone
are armed. The sensors assigned to the
Home zone are disarmed.
For more information on zone setup, please
refer to the instructions on page 14 of this
manual.

Emergency Mode

Hold the "# " button for 3 seconds. The
SOS
alarm is triggered immediately and the
siren rings out. At the same time, the control
panel dials the stored phone numbers.
Setup from the Control Panel
The control panel of your alarm system
features an LCD display that enables you to
navigate through the menu of the control
panel and set up your alarm system.
To enter the setting menu, type
code + Enter] on the control panel.
Default admin code: 123456
In the table on the next page, each column
represents a menu or a sub menu. Each
menu or submenu will be displayed on one
of the two lines of the LCD display. On the
LCD display, the current menu, submenu, or
setting is shown on the line at the bottom,
while the previous menu or submenu is
shown on the line at the top.
Navigate and select the setting you wish
to modify with the keys " " or " ", and enter
each menu or sub menu by pressing "Enter".
How to use the keyboard
" " = delete
" " = move forward
" " = move backward
"Enter" = select / confirm
"Esc" = back / previous step in the menu /
cancel
The tables on the next pages summarize
all the settings that can be accessed and
modified on the control panel.
[your admin
9 9