Hoover Dynamic NEXT Manual Del Usuario página 15

TROUBLESHOOTING
What Might be the Cause of...
Defects you can remedy yourself
Before calling GIAS Service for technical advice
please run through the following checklist. A
charge will be made if the machine is found to be
working or has been installed incorrectly or used
incorrectly.
If the problem persists after completing the
recommended checks, please call GIAS
Service, they may be able to assist you over the
telephone.
Time display to end could change during
drying cycle. The time to end is
continuously checked during the drying
cycle and the time is adjusted to give the
best estimation time. The displayed time
may increase or decrease during the cycle
and this is normal.
Drying time is too long/clothes are not dry
enough...
•
Have you selected the correct drying
time/programme?
•
Were the clothes too wet? Were the clothes
thoroughly wrung or spindried?
•
Does the filter need cleaning?
•
Is the dryer overloaded?
•
Has the option been selected from a previous
cycle?
The dryer does not operate...
•
Is there a working electricity supply to the
dryer? Check using another appliance such as a
table lamp.
•
Is the plug properly connected to the mains
supply?
•
Is there a power failure?
•
Has the fuse blown?
•
Is the door fully closed?
•
Is the dryer switched on, both at the mains
supply and at the machine?
•
Has the drying time or the programme been
selected?
● Has the machine been switched on again after
opening the door?
The dryer is noisy...
•
Switch off the dryer and contact GIAS
Service for advice.
The Indicator is on...
•
Does the filter need cleaning?
The Indicator is on...
•
Does the water container need emptying?
CUSTOMER SERVICE
Should there still be a problem with your dryer
after completing all the recommended
checks, please call GIAS Service for advice.
They may be able to assist you over the
telephone or arrange for a suitable
appointment for an engineer to call under the
terms of your guarantee. However, a charge
may be made if any of the following applies to
your machine:
•
Is found to be in working order.
•
Has not been installed in accordance with
the installation instructions.
•
Has been used incorrectly.
Spares
Always use genuine spares, available direct
from GIAS Service.
GIAS Service
For service and repairs call your local GIAS
Service engineer.
T h e m a n u f a c t u r e r d e c l i n e s a l l
responsibility in the event of any printing
mistakes in this booklet. The manufacturer
also reserves the right to make appropriate
modifications to its products without
changing the essential characteristics.
15 EN