Starting And Stopping The Engine - Probuilder 62761 Manual De Instrucciones

Preparations before start
Remember to fi ll the generator with oil
before using it!
Check the oil level as described under
Checking the oil level.
Check the petrol level on the petrol gauge
(3). Top up the petrol if necessary.
Check the fuel cap (2) is correctly closed after
fi lling.
Check no electrical appliances are connected
to the generator's power outlets (5, 6).

Starting and stopping the engine

Starting the engine
Turn the petrol cock (16) to the ON position.
Set the choke (20) to the OFF position to
make the petrol mix richer if the engine is
cold. Set the choke to the ON position if the
engine is warm.
38
br
cl
Set the main switch (12) to the ON position.
bn
Pull the starter handle (15) all the way out
until the engine starts. Repeat if the engine
fails to start fi rst time.
Set the choke (20) to the ON position once
the engine is warm.
Do not allow the starter handle to recoil onto
the generator. Allow the cable to rewind
slowly.
Never pull the starter handle when the
engine is running to avoid damage to the
engine.
Set the switches (6, 8) to the ON position to
switch on the power outlets.
Stopping the engine
Switch off or disconnect all electrical
equipment before stopping the engine.
Place the switches (6, 8) in the OFF position.
Set the main switch (12) to the OFF position.
Turn the petrol cock (16) to the OFF position.