Flex FX1351 Manual Del Operador página 11

DIRECTION-OF-ROTATION (FORWARD/
CENTER-LOCK/REVERSE) SELECTOR
WARNING
selector in the "OFF" position (center-lock)
to help prevent accidental starts and
possible injury.
Your tool is equipped with a direction-of-rotation
selector, located above the variable-speed
trigger switch. This selector is used to change
the direction of rotation of the bit and to lock the
variable-speed trigger in the "OFF" (center-lock)
position.
a. Position the direction-of-rotation selector to
the far left of the tool to drive screws in or
tighten bolts/nuts (Fig. 6).
b. Position the direction-of-rotation selector to
the far right of the tool to remove screws or
loosen bolts/nuts (Fig. 6).
c. Position the switch in the "OFF" (center-
lock) position to help reduce the possibility of
accidental starting when not in use.
NOTICE: To prevent gear damage, always allow
the impact driver to come to a complete stop
before changing the direction of rotation.
NOTICE: The impact driver will not run unless
the direction-of-rotation selector is engaged fully
to the left or to the right.
VARIABLE-SPEED TRIGGER SWITCH (FIG. 7)
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned ON or
OFF by depressing or releasing the variable-
speed trigger switch.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
ADJUSTMENTS
After tool use, lock the
direction-of-rotation
Fig. 6
WARNING
Therefore, the direction-of-rotation (forward/
center-lock/reverse) selector should always
be locked in the center position when the
tool is not in use or when carrying it at your
side.
Fig. 7
Variable-Speed
Trigger Switch
-11-
Battery tools are always in
operating condition.