Jump-N-Carry JNC8550 Manual Del Usuario página 5

4. C harge until the wall charger indicates charge complete.
Note: T he unit can remain connected to the wall charger indefinitely without adverse
consequences.
Directly charging the ultracapacitor for immediate use.
Note: We refer to this method as "for immediate use" because ultracapacitors, while
very powerful, do not hold a charge for more than a few days. This method
should only be used to charge the unit when it will be used to jump start very
soon after charging the ultracapacitor.
1. Connect the pin jack end of the supplied 12V cable to the Jump-N-Carry via the
12V CAPCITOR CHARGE PORT in the control panel.
2. Connect the 12V Male Pulg end of the 12V cable to a 12V power port.
3. C harging progress is indicated by the % READY TO JUMP display on the right of
the control panel.
4. Charge until % READY TO JUMP display indicated 100% state of charge.
Jump Starting Instructions
Note: The unit is designed to be used as a jump starter only when the ultracapacitor is
above 80% ready to jump as indicated on the control panel.
1. Use in a well ventilated area.
2. Shield eyes. Always wear protective eyewear when working near batteries.
3. Review this instruction manual and the instruction/safety manual provided by the
manufacturer of the vehicle being jump started.
4. Turn ignition off before making cable connections.
5. Stay clear of batteries while jump starting.
6. Clamp the positive (red +) clamp to the positive terminal on the vehicle battery (for
negative ground system), or an alternate vehicle starting point as recommended by
vehicle manufacturer.
7. C lamp the negative (black –) clamp to the vehicle ground (non-moving metal part,
such as the vehicle frame).
8. Make sure the cables are not in the path of moving engine parts (belts, fans, etc.).
9. W hen connection is made, the VEHICLE VOLTAGE display on the control panel will
display the disabled vehicle's state of charge and the unit will indicate the next step
to take:
9a. P RESS JUMP START – the disabled vehicle's state of charge is high enough to
use to charge the ultracapcitor. Press JUMP START and the unit will count up
as the ultracapacitor is charged to full from the disable vehicle's battery and the
Green READY LED is lit. The unit will sound an audible beep indicating it is ready
to jump start. The jump starter function is engaged for 30 seconds after which the
unit will return to idle mode.
5