Tabla de contenido
Idiomas disponibles
Idiomas disponibles
MAINTENANCE AND INSPECTION INSTRUCTIONS (CONTINUED)
Intake Air Filter Maintenance
Removal, Inspection and Replacement (Figure 7).
The intake filter element should be removed and checked periodically.
A clogged intake filter can decrease compressor performance and
cause the compressor to overheat.
1. Rotate the filter cover counter-clockwise and remove.
2. Remove the filter element and inspect.
3. If the filter element is dirty or clogged, replace it.
4. Reinstall filter and cover.
IMPORTANT: Locate unit as far from spraying area as hose will
allow to prevent overspray from clogging filter.
End of Operation/Storage
1. Turn AUTO/OFF switch to the OFF position.
2. Unplug power cord from wall outlet and wrap around handle to prevent damage when not in use.
3. Wearing safety glasses drain tank of air by pulling the ring on the safety valve. Use other hand to deflect fast
moving air from being directed toward your face.
4. Drain tank of condensation by opening drain valve on bottom of tank. Tank pressure should be below 10 psi
when draining tank.
5. Air hose should be disconnected from compressor and hung open ends down to allow any moisture to drain.
6. Compressor and hose should be stored in a cool, dry place.
Moisture in compressed air will form into droplets as it comes from an air compressor pump.
When humidity is high or when a compressor is in continuous use for an extended period of
time, this moisture will collect in the tank. When using a paint spray or sandblast gun, this
water will be carried from the tank through the hose, and out of the gun as droplets mixed
with the spray material.
IMPORTANT: This condensation will cause water spots in a paint job, especially when
spraying other than water based paints. If sandblasting, it will cause the sand to cake and
clog the gun, rendering it ineffective.
A filter in the air line, located as near to the gun as possible, will help eliminate this moisture.
OPERATION
Check Oil Level
Drain Tank
Check Air Filter
Check Safety Valve
Clean Unit
Change Oil
MOISTURE IN COMPRESSED AIR
MAINTENANCE SCHEDULE
DAILY
WEEKLY
●
●
●
●
13
Filter
element
Filter cover
Figure 7 - Intake filter maintenance
MONTHLY
3 MONTHS
●
●
Tabla de contenido
