Angle Adjustment (Intermittent Mode) - Carl Valentin Dynacode Serie Instrucciones Abreviadas Y Recomendaciones De Seguridad

Dynacode

Angle adjustment (intermittent mode)

The installation angle of the printhead is default 26° to the print surface. However, manufacturing tolerances of printhead and
mechanics can require another angle.
CAUTION!
Damage of printhead by unequal use!
Higher wastage of ribbon by faster ripping.

Change factory settings only in exceptional cases.

Loosen slightly two Allen head screws (A).

Move adjusting part (B) to adjust the angle between printhead and printhead support.
move downwards = decrease angle
move upwards = increase angle

Tighten again the Allen head screws (A).

Start a print order with approx. 3 layouts to check the correct unwrinkled ribbon run.
NOTICE!
The slots (C) serve for position control. Pay attention to a parallel adjustment.
116 English