Install The Myq Smart Garage Hub; Door Sensor - Chamberlain Smart Garage MYQ-G0301 Manual

Install the MyQ Smart Garage Hub

Install the MyQ Smart Garage Hub on the ceiling 4-6 feet from the garage door
opener, and within 4 feet from an AC power outlet . The MyQ Smart Garage Hub light
MUST be visible if you're standing in the doorway of the garage.
1. Use the MyQ Smart Garage Hub bracket as a template to drill 5/32" pilot holes.
2 . Attach the bracket .Slide the MyQ Smart Garage Hub onto the bracket .
3. P lug it in and confirm the hub's green LED turns on solid. If the hub's LED does
not turn solid green within a few minutes, see page 10.
4 . Attach the warning label to the wall next to the door control .
Door Control
Install the door sensor
1 . Remove the pull tab from the door sensor to activate the battery .
2. T est the door sensor by pushing the test button and confirming the LED on
the door sensor blinks . If the LED on the door sensor does not blink, see
Troubleshooting on page 9 .
3 . Install the door sensor on the top panel of the garage door
using the fastening strips or provided hardware .
Warning Label
MyQ Smart Garage
Light
TIP: Wrap excess power
adapter cable around the
mounting bracket.
"TOP" MUST a lways face UP
LED
Test
Button
Press
- 22 -
Hub
Fastening
Strips
OR
Screws
CR2450 Battery