Tabla de contenido
Idiomas disponibles
Idiomas disponibles
2
4
7. Insert the solution tank tap tie chain (6) in the coupling in the tap control handle (7) (Fig.8).
5
7
8. Insert the cleaning solution tube (7) into the hole in the
solution tank (Fig.9).
7
8
10
Fill the solution tank only when the column is in vertical position, by
proceeding as follows:
1. Remove the solution tank cap (1) (Fig.1).
2. Fill with clean water, at a temperature no higher than 50°C.
3. Add the liquid detergent to the tank in the concentration and
manner indicated on the detergent manufacturer's label. The
formation of excess foam could damage the internal components
of the appliance, so only use the minimum amount of detergent
needed.
1
3
5
7
6
4
8
INSERTING THE DETERGENT SOLUTION (OPTIONAL)
1
2
12
12
6
7
9
9 .Connect the cleaning solution tube (7) with the quick-release filter
attachment and push it to the bottom of the tank. (Figure 10).
4. Insert the solution tank cap (1) (Fig.2).
ATTENTION: You are advised to always wear protective
gloves, to avoid the risk of serious injury to your hands.
ATTENTION: We recommend that you vacuum at intervals
the dirt-loaded foam with a vacuum cleaner for liquids.
1
EN
3
1
Capítulos
Tabla de contenido
