Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The flow rate of water entering the heater must not exceed:
Heating element (MAIN)
Pool water (SECONDARY)
A higher flow rate will require the installation of a by-pass to prevent damage to
the element(s).
¡Important!
A good use of this device it also means:
Follow all the information included in the installation instructions
and, follow inspection and maintenance instructions.
Any other application will not be considered as normal use. The manufacturer
will not be then responsible for any damage that it could appear.
Other uses could be only possible after the manufacturer's agreement and
approval.
Changes and adaptations are forbidden due to safety reasons.
DANGER SITUATIONS
DANGER SITUATIONS
DANGER SITUATIONS
DANGER SITUATIONS
The heater could lead to danger situations if:
Working pressure is higher than 3 bars for pool water and 10 bars
for boiler. Then leakages could appear with danger of burns.
PRECAUTION
Boiler side connections could reach 100ºC. The heater could reach
this temperature if it is not completely full of pool water.
CARE
Plastic piping could suffer thermal stresses that could lead to
damage.
PRECAUTION
If the cycle it is not closed by means of a circulating/debugging
puma, the heater could reach the water boiler temperature and the
exchanger could be damaged.
PRECAUTION
If metal particles have entered into the internal heating coil it could
appear leakages due to rusting originated by contact and the boiler
water could contaminate the pool water.
PRECAUTION
10 bar máx.
3 bar máx.
3
ENGLISH
Tabla de contenido
