Tools And Materials; Before You Begin - THE BOLD LOOK OF KOHLER K-12100 Guia De Instalacion

Tools and Materials

Safety
Drill
Glasses
Claw
Hammer
Thank You For Choosing Kohler Company
We appreciate your commitment to Kohler quality. Please take a few minutes to review this manual before
you start installation. If you encounter any installation or performance problems, please don't hesitate to
contact us. Our phone numbers and website are listed on the back cover. Thanks again for choosing Kohler
Company.

Before You Begin

CAUTION: Risk of product damage. Install the shower module on an adequately supported, level
subfloor. The shower module requires no additional support when the subfloor is level and square
with the stud framing. Use shims for additional support if the subfloor is uneven. Do not install the
shower module over open floor joists.
CAUTION: Risk of product damage. To avoid rust marks on your product, ensure the large head nails
or screws are galvanized. If using galvanized screws, do not overtighten the screws. Excessive
tightening can damage the wall flange.
Please read these instructions carefully to familiarize yourself with the required tools, materials, and
installation sequences. Follow the sections that pertain to your particular installation. This will help
you to avoid costly mistakes.
Observe all local plumbing and building codes.
A variety of installations are possible. These instructions show suggested installation procedures.
Your particular installation may require other construction techniques.
Avoid flexing the side walls to prevent damage to the module.
Unpack and inspect the shower module for damage. If you find any damage, do not install the
module. Report the specific problem to your dealer immediately. After inspection, return the shower
module to the carton until you are ready to install it.
Insulate all exterior walls before installation.
You must install this shower module to an adequately supported, level subfloor.
Be sure that you have enough access to move the module into the construction area. One-piece
shower modules are too large to fit through standard door openings. Set the module within the
installation area prior to the completion of the framing. Another option is not to install the studs in
one wall or install the studs without nailing, to allow you to move the module into place.
1030529-2-B
Screwdriver
Square Knife
Tape
Pencil
Measure
2
Level Sealant
Plus:
• Common Woodworking Tools
and Materials
• Galvanized #6 Large Head
Screws or Nails
• Drop Cloth
• 2x4s or 2x6s and 2x2s
• Water Resistant Wall Material
• Hole Saw
Plumbers
Putty
Kohler Co.