Operation Modes; Programming Mode - ACESOL FUTURE LCD Serie Manual De Instalación

English
P
/ Programming mode. In this mode you can select the operating programmes for
the Auto mode and configure the user programmes. There are 13 options that will be
described in section 5, Operating modes.

5. Operation modes.

- Manual mode:
from that programmed in Auto mode is selected with keys + and -. Press the MODE
key again to return to the programmed Auto mode.

- Programming mode:

- To select default factory programmes (P1 to P9)
- To configure programmes designed by the user (U1 to U4)
Default programmes have set timetables and allow the highest temperature (HI) and
the lowest temperature (LO) to be set, giving the possibility of the latter being 0 if we
wish the emitter to turn off for certain periods of time. This temperature selection is
made via SETUP (see section on SETUP CONFIGURATION).
- Default programmes
To select one of the 9 default programmes, press the MODE key until position P is
reached. The last programme used will appear on the screen (P1 will appear the first
time). Then press + to change the programme (P1, P2, P3...); in order to select the
programme simply stop pressing it when you reach the default programme that best
adapts to your needs. If no key is pressed for a few seconds once the selection is
made, the programming entered for the current day of the week will be shown; press
key - to change the day and see the programming for the rest of the days.
The 24 hours of the day appear on the right - hand side of the screen, followed by a
series of strips that may be lit or not; the strips corresponding to the high temperature
hours (HI) will light up by selecting one of the default programmes.
- For example: if P1 is selected, the strips corresponding to the following hours will
light up: 08:00, 09:00, 18:00, 19:00, 20:00, 21:00 and 22:00, for weekdays. In the case
of Saturdays and Sundays the strips corresponding to hours 09:00, 10:00, 11:00,
12:00...up to 23:00 will light up.
- Programmes that can be configured by the user.
To select one of the 4 programmes that can be configured by the user, press the
MODE key until the cursor is in position P. The last programme used will appear on the
screen (P1 will appear the first time).
A programme will be skipped each time the + key is pressed, first going through the
default programmes (P1 to P9) until reaching option U1, the first "empty"
programme ready to be configured. Press key + to continue skipping through these
(U2, U3, U4...). Once in the U programme selected, the clock will blink (00:00), on day
1 of the week. By successively pressing key + the strips corresponding to the hours
chosen will light up on the right - hand side of the screen. Then select the temperature
you want for those hours by pressing the MODE key (the temperature indicator in the
upper part of the screen will blink), increasing or reducing the temperature using keys
+ and -.
After configuring the temperature, pressing MODE once will take you back to the
previous step. Choose another hour strip and another temperature for this strip,
ACESOL
The emitter will go into manual mode if a temperature different
This function allows the following:
(page 38):
- Installation manual - Instructions for use
LCD
EN
17