Important Safety Instructions - PowerShot 208 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using Electric Tools, basic safety precautions should always be followed to
reduce the risk of fire, electric shock, and personal injury, including the following:
11. KEEP WORK AREA CLEAN. Cluttered areas and benches invite injuries.
12. CONSIDER WORK AREA ENVIRONMENT. For indoor use only. Don't expose power tools to
rain. Don't use power tools in damp or wet locations. Keep work area well lit.
13. KEEP CHILDREN AWAY. All visitors should be kept away from work area. Do not let visitors
contact tool or extension cord. Supervise the use of this tool by children.
14. STORE IDLE TOOLS. When not in use, tools should be stored in dry, high or locked-up place
— out of reach of children.
15. USE SAFETY GLASSES.
16. DON'T ABUSE CORD. Never carry tool by cord or yank it to disconnect from receptacle.
Keep cord from heat, oil, and sharp edges.
17. DON'T OVERREACH. Keep proper footing and balance at all times.
18. DISCONNECT TOOLS. When not in use, before servicing and when changing accessories.
19. This tool is recommended for indoor use only.
10. STAY ALERT. Watch what you are doing. Use common sense. Do not operate tool when you
are tired.
11. DO NOT TOUCH THE HEATED NOZZLE OF THE GLUE GUN OR THE HOT MELT GLUE. The
operating temperature of General Purpose and 2 Temperature Glue Guns can reach 380°F.
(Low temperature models reach 260°F).
12. Never attempt to use any material other than recommended adhesive, sealer, or caulk
sticks in the glue gun. For example: Do not attempt to melt crayons or candles. Permanent
damage to the glue gun could result.
13. Do not use hot melt glue to take the place of structural fasteners.
14. The adhesive used with this glue gun will begin to soften at about 140°F. Don't use the glue
on objects that will be subjected to temperatures of 140°F or above.
15. DO NOT ATTEMPT TO REMOVE THE UNUSED PORTION OF A GLUE STICK FROM THE TOOL.
16. Never attempt to force cool the gun after use by immersing any part of it in water or any
other liquid. Allow the gun to air cool only.
17. ALWAYS BE SURE THAT THE GLUE GUN IS COOL BEFORE STORING IT.
18. THE GLUE GUN IS ON AS SOON AS IT IS PLUGGED IN.
19. WHEN NOT IN USE, DO NOT LEAVE THE GLUE GUN PLUGGED IN FOR AN EXTENDED TIME.
DO NOT LEAVE UNATTENDED.
20. AVOID ACCIDENTAL GLUE DISCHARGE. Feeding or pushing adhesive stick with too much
force into a heated gun may cause hot adhesive to be unexpectedly expelled from nozzle.
21. DO NOT store the glue gun in direct sunlight for extended periods.
NOTE: This tool will become quite warm during use. This is normal and does not indicate a
problem.
READ ALL INSTRUCTIONS
SAVE THESE SAFETY RULES FOR FUTURE USE