Tabla de contenido
2.
Connections
Series Connection - 4 Ohm
Connexion en série - 4 ohms
Conexión en serie - 4 Ohms
+
-
-
+
+
-
+ -
-
+
R
L
Speaker Terminal
Borne de haut-parleur
Terminal de bocina
NOTE: This amplifier allows 2-speaker or 4-speaker stereo output. Refer to the
connection diagram above for your wiring configuration.
NOTE: The speaker terminal will accept a 10-18 AWG wire. Follow local codes for
routing speaker wires.
Ensure the amplifier power supply is disconnected.
Using a wire stripper, remove approximately 1/2" (13 mm) of insulation from the
speaker wire.
Insert the wire into the appropriate positive (+) or negative (-) and right (R) or left
(L) terminal connector.
Repeat for the remaining speaker wires.
Reconnect the amplifier power using the provided power adapter.
Verify that the status LED light turns on.
For audio input from a wired device, connect the 3.5 mm cable to the line-in port
on the back of the amplifier.
Kohler Co.
Parallel Connection - 8 Ohm
Connexion parallèle - 8 ohms
Conexión en paralelo - 8 Ohms
-
+
+
-
Or/ou/O bien
+
-
+
-
+
+
-
-
R
L
13
-
+
+
-
-
+
+ -
-
+
R
L
1193890-2-B
Tabla de contenido
