Probuilder 10666 Manual De Instrucciones página 35

Attaching tools
Press the spindle lock (4) in and turn the axle
until it locks.
Undo the collar on the bushing (1). If
necessary use the spanner (12).
Insert the shaft on the required tool into the
bushing. The shaft must be no more than 45
mm long and must be inserted far enough
that no more than half of the length of the
shaft is outside the bushing.
Tighten the collar using the spanner.
Release the spindle lock. The multisander is
now ready for use.
Remove the tool in reverse sequence.
Use
When engraving, hold the multisander by
the front grip like a pencil, with the buttons
facing upwards.
For large jobs, hold the multisander like a
hammer with the buttons facing upwards.
Always hold the multisander so that the
ventilation slots (6) are not covered by your
hand.
Press and hold the on/off button (5) for 1.5
seconds to switch the multisander on. The
multisander starts at 15,000 rpm and the LED
work light (2) comes on.
GB
35