Technical Data; Special Safety Instructions - Probuilder 10666 Manual De Instrucciones

CORDLESS MULTISANDER
Introduction
To get the most out of your new cordless
multisander, please read through these
instructions before use.
We also recommend that you save the
instructions in case you need to refer to them
at a later date.

Technical data

Battery:
Charging time:
Speed settings:
Speed:
Bushing:
Charging station: 100-240 V ~ 50/60 Hz,
output 9 V, 50-2,500 mAh, IP20
Incl. charging station and 40 accessories:
6 x cutting discs (Ø20×0.4 mm)
8 x cutting discs (Ø24×0.4 mm)
3 holders for cutting discs
10 assorted grindstones
1 holder for felt
1 felt wheel (Ø25×6.3 mm)
1 felt wheel (Ø12.7×6.3 mm)
4 sanding belts (12.7×12.7 mm)
1 shaft for sanding belt (Ø3.2 mm)
2 drill bits
2 HSS milling cutter (Ø3.2 mm)
1 wrench
1 wet stone
Sound pressure, LpA: 75.8 dB(A), K 3.0 dB(A)
Sound eff ect, Lwa
Vibration:
32
7.2 V 1000 mAh Li-ion
1 hour
5,000-25,000 rpm
Ø3.2 mm
86.8 dB(A), K 3.0 dB(A)
2.11 m/s 2 , K 1.5 m/s

Special safety instructions

Sparks may be generated when sanding
metal surfaces. Avoid using in fl ammable
surroundings and in the vicinity of fl ammable
materials and fl uids.
Do not use the multisander on alloys with a
magnesium content of 80% or above as they
are fl ammable.
Hold the multisander tightly, especially when
starting. Vibration can occur due to motor
torque when starting.
Wear safety goggles when using the
multisander.
5
Never hold the item to be worked in your
hand. Clamp securely in a vice or similar.
Keep hands and fi ngers at a safe distance
from rotating tools.
Use accessories approved for the
multisander's minimum and maximum
speeds only.
Use only accessories supplied or approved by
the manufacturer.
Do not use drill bits with damaged necks.
Never touch the spindle lock while the
multisander is in use!
Check that the item does not contain nails,
screws or other objects that may damage
rotating tools.
2