RISK OF INJURY
Before cleaning and servicing the extractor
hood, isolate it from the power supply by
pulling out the mains plug or switching of
the fuse.
Appliance surfaces
NOTE: Observe the warranty regulations in
the enclosed service booklet.
The appliance surfaces and controls are
scratch-sensitive. Therefore observe the
following cleaning instructions:
– Avoid cleaning the extractor hood with dry
cloths, abrasive sponges, scouring agents,
cleaning agents containing sand, soda,
acid, chlorine or any other aggressive
substances.
– Clean the appliance surfaces and controls
with a soft, damp cloth, washing-up liquid
or a mild window cleaner only.
– Do not scrape of dried dirt, but moisten
with a damp cloth.
– Clean carefully in the area of the controls
to avoid liquid from getting into the
electronics.
NOTE: Clean the stainless steel surfaces in
the direction of the ground surface only!
Do not use stainless steel cleaner for the
control buttons!
Removing and installing the grease ilters
Before removing and installing the grease
ilters, always follow the instructions and
warnings in the chapter entitled "Safety
instructions"!
Removing and installing the metal-mesh
grease ilters
1. Open the lock and fold down the grease
ilters. In doing so, hold the underside of
the grease ilters with your other hand.
2. Clean the grease ilters.
3. Reinsert the cleaned grease ilters.
13
Looking after the appliance
Suitable cleaning agents and care
products for your appliance can be
purchased via the Hotline or from the
Online Shop (see cover page).
Metal-mesh grease ilters
The inserted metal-mesh grease ilters
absorb the grease particles from the kitchen
fumes.
The ilter mats consist of ire-proof metal.
RISK OF FIRE
As the ilters become more saturated with
greasy residue, the lammability increases.
The function of the extractor hood may also
be impaired.
The risk of ire is prevented by cleaning
the metal-mesh grease ilters in good time.
When cleaning the grease ilters, also
remove grease deposits from the accessible
parts of the housing with a damp cloth.
Cleaning the metal-mesh
grease ilters ...
Under normal operation (daily 1 to 2
hours), the metal-mesh grease ilters must
be cleaned 1x month.
NOTE: The unlocking devices for the lue
duct must not be actuated. They are used
exclusively by customer service.
Cleaning and care
... in the dishwasher
The metal-mesh grease ilters can be
cleaned in the dishwasher. Slight
discolouration may occur but this will not
afect the function of the grease ilters.
The ilters must be placed loosely in the
dishwasher. They must not be wedged in.
NOTE: Do not clean heavily saturated metal-
mesh grease ilters together with utensils.
... by hand
When cleaning by hand, soak the grease
ilters in a hot detergent solution, brush of
the dirt, rinse thoroughly and leave to dry.
Do not use any aggressive, acidic or
alkaline cleaning agents.
If dirt is particularly stubborn, we
recommend using a special grease solvent
spray. This can be ordered via the Online
Shop.
13