Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Warning: electrical outlet wiring must comply with local building codes and other applicable regulations to reduce the risk
of fire, electrical shock and injury to persons.
Warning: Do not use this heater if any part of it has been under water. Immediately call a qualified service technician to
inspect the firebox and replace any part of the electrical system which has been under water.
coMponenTs anD funcTions
•
the heat produced from the heater is the product of 4 Infrared Quartz Bulbs (375W each). these bulbs, within a stainless steel
thermal conduction housing, warm the air as it passes through the inner chamber of the heater. the incorporated twisted
style of the quartz bulbs increases the energy efficiency of the heater unit.
•
an aC cross-flow fan pushes air across the 4 Infrared Quartz Bulbs. Cross-flow fans create a wide flow of air using a
cylindrical-shaped impeller. air is drawn inside the Portable Heater, flows along the circumference of the chamber and
over the infrared quartz bulbs, and is blown out laterally creating a uniform flow of warm air.
•
the heater has a delay start function which controls the aC cross-flow fan. the purpose of the delay start function is to
allow the infrared quartz bulbs to heat up before the fan begins to circulate the airflow. In addition, the aC Cross Flow
Fan will continue to circulate the airflow after the power is turned off to draw the warm air from the heater, cooling the
unit down.
•
the air flow exits through the front of the heater, passing over a copper plate. this copper plate is made of red copper,
this conductive material reflects the infrared light and boosts the heater's energy efficiency.
•
Convenient, digital LeD display is easy-to-use, stylish and compliments the heater.
operaTing insTrucTions
1.
Inspect the heater to ensure it has not been damaged during shipment before operation.
Do noT operaTe The heaTer if any DaMages are DeTecTeD. conTacT your DeaLer iMMeDiaTeLy.
Note: the "
" and "
up
down
2.
Plug the power cord directly into a conventional 120V 15amp outlet and press the master power
switch on the back of the heater. then, press the power button on the front control panel or on the
remote control to start the unit. the LeD display will show the default temperature setting: 72˚F/22˚C
Note: If the current ambient temperature is greater than the set temperature, the
will not operate.
4
" buttons on the remote control serve two functions:
/
adjust
with an up arrow or adjust
time
temp
adjust
/
with down arrow or adjust ˚C/˚F settings
time
temp
/
settings
hi
low
˚C
˚F
˚F
˚C
/
/
display, fan and quartz bulbs
hi
low
Tabla de contenido
