Tabla de contenido
Idiomas disponibles
Idiomas disponibles
user insTrucTions
1.
any repairs to this appliance should be carried out by qualified/authorized service personnel only.
2.
under no circumstances should this appliance be modified. Parts having to be removed for servicing must be replaced
with original "OeM" (original equipment manufacturers) parts only.
3.
this heater is to be cleaned with a damp cloth (water) only.
iMporTanT: always unplug the power cord before cleaning the unit. Do not use any abrasive cleaners on the unit.
4.
this heater is equipped with a tip over safety switch. the heater will shut off if the unit accidentally tips over.
5.
unplug this heater when not in use.
grounding instructions
this heater is for use on 120 volts. the cord has a plug as shown in figure 1a in the
diagram. an adapter as shown in figure 1C is available for connecting three-blade
grounding-type plugs to two-slot receptacles. the green grounding lug extending
from the adapter must be connected to a permanent ground such as a properly
grounded outlet box. the adapter should not be used if a three-slot grounded
receptacle is available. (note: Grounding adapter use prohibited in Canada)
Locating your heater
When choosing a location for your new heater, ensure the general instructions are followed. also, for best effect install the
heater out of direct sunlight.
It is safe to set the heater close to non-combustibles. Do noT sTore or use gasoLine or oTher fLaMMaBLe
Vapors or LiquiDs in The ViciniTy of This or any oTher appLiance.
specifications
Voltage
Frequency
Watts / amps.
Heat Source
Heater rating
electrical connection
a 15 amp, 120 Volt, 60 Hz circuit with a properly grounded outlet is required to operate this appliance. Preferably, the heater
will be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow
when the heater is in operation. the unit comes standard with a 5.8 ft (1.8 m) long 3 wire cord, exiting out the back of the
heater. Plan the installation to avoid the use of an extension cord. If an extension cord must be used, it must be a minimum 14
ga, 3 wire with grounding type plug and connector and rated not less than 1875 watts. the extension cord shall not be more
than 20 ft (6 m) in length.
120 V
60 Hz
750 - 1500W / 12.5a
4 Infrared Quartz Bulbs
5115 Btu's
Grounding Pin
Cover of Grounded Outlet Box
C
adapter
Grounding Lug
Metal Screw
Cover of Grounded Outlet Box
a
B
3
Tabla de contenido
