Troubleshooting; Before Calling For Service; The Air Conditioner - Kenmore 580.74093 Manual Del Propietário

Acondiclonado de aire a traves de pared
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

BEFORE CALLING FOR SERVICE
Check
the following
list to be sure a service
call is really necessary.
A quick
reference
to this manual
may
help you avoid an unneeded
service
call.
THE AIR CONDITIONER
WILL NOT OPERATE
Check
if...
Then...
Wall plug disconnected.
House fuse blown or circuit breaker tripped.
Power is OFF.
Unit was turned off and then on too quickly.
TEMP Control set warmer than room temperature.
Push plug firmly into wall outlet.
Replace fuse with time delay type or reset circuit breaker.
Push the power button.
Set unit off and wait 3 minutes before restarting.
Set TEMP Control to a lower number.
AIR
FROM
UNIT
DOES
NOT FEEL
COLD
ENOUGH.
Check
if...
Then...
FAN SPEED set at LOW.
Push FAN SPEED button to set at HI.
TEMP Control set too warm.
Set TEMP Control to a lower temperature.
Room temperature below 70°F (21°C).
Cooling may not occur until room temperature rises above 70°F (21°C).
Temperature sensing tube touching evaporator coil,
Straighten tube away from evaporator coil.
located behind front grille.
THE AIR CONDITIONER COOLING, BUT ROOM ISTOO WARM - ICE FORMING ON COOLING COIL BEHIND INLET GRILLE.
Check
if...
Then...
Outdoor temperature below 70°F (21°C).
To defrost the coil, set the MODE to FAN, FAN speed to High.
Air filter may be dirty.
Clean air filter. Refer to Maintenance section of owner's manual.
To defrostthe coil,set the MODE to Cool, Fan speed to high, and the
TEMP Control set too low.
Temp control to a higher temperature.
THE AIR CONDITIONERCOOLING, BUT ROOM ISTOO WARM
Check
if...
Then...
Dirty air filter- air restricted.
Clean air filter. Refer to Maintenance section of owner's manual.
TEMP Control set too warm.
Set TEMP Control to a lower temperature.
Front of unit is blocked by drapes, blinds, furniture, etc.
Clear blockage in front of unit.
Air distribution is restricted.
Doors, windows, registers, etc. open. Cold air escapes.
Close doors, windows, registers, etc.
Unit recently turned on in hot room.
Allow additional t imeto removestoredheatfromwalls,ceiling,floor,and furniture.
THE
AIR CONDITIONER
TURNS
ON AND
OFF
RAPIDLY.
Check
if...
Then...
I Outside temperature is extremely hot.
I Set FAN SPEED on HIGH to minimize the cooling load.
I
NOISE WHEN UNIT IS COOLING.
Check
if...
Then...
L Sound of fan hitting water-from the moisture removal system.[ This is normal when humidity is high_. C lose doors, windows, and registers.
/
Window vibration - poor installation.
_ Refer to nsta at on nstruct ons or check wth nsta er.
WATER
DRIPPING
INSIDE
ROOM
WHEN
UNIT
IS COOLING.
Check
if...
Then...
The air conditioner is improperly installed,
installationTilt
air conditioner
instructions
slightly or tocheck
the outside
with installer,
to allow water drainage. Refer to
WATER
DRIPPING
OUTSIDE
WHEN
UNIT
IS COOLING.
Check
if...
Then...
The unit is removing large quantities of moisture
This is normal during excessively humid days.
from humid room.
-17-

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

580.74130

Tabla de contenido