Dispaly - Kenmore 580.74093 Manual Del Propietário

CONTROL PANEL
[TIMER
- SHUT-OFF TIME
• You will usually use shut-off time while you sleep.
• If unit is running, use Timer to set number of hours
until shut-off.
• For your sleeping comfort, once Time is set, the
Temperature setting will raise 2°F after 30 min.,
and once again after another 30 min.
• Push Timer button to advance setting from 1Hour
2Hours _... * 12Hours maximum.
- START TIME
• If unit is off, Timer sets number of hours before unit
starts.
• Push Timer button to advance setting from 1Hour
2Hours , ... * 12Hours maximum.
REMOTE CONTROL SIGNAL
RECEIVER
• Use this button to automatically control the
temperature of the room.
The temperature can be set within a range
of 60°F to 86°F by increments of I°F.
• The setting appears in the display.
POWER
• To turn the air conditioner ON, push this
button.
To turn the air conditioner OFF, push the
button again.
• This button takes priority over any other
button.
• When you first turn it on, the unit is in
cool mode, High fan speed, Temperature
setting at 72°F.
FAN SPEED
• Every time you push this button, it
advances the setting as follows:
{High * Low * Med _ High}
MODE
- You push this button to shift mode of operation from COOL _ ENERGY SAVER _ FAN.
- ENERGY SAVER:
• The fan stops when the compressor stops cooling. Approximately every 3 minutes the fan will be turned
on so that the unit can check the room air temperature to determine if cooling is needed.
In the event at a power failure, the unit will run at the previous setting once power returns.
-13-