Use And Maintenance Instructions; Operation; Control Panel Symbols Fig. 9; Switching On The Machine - edenox T-OEM-350 Instrucciones De Instalación, Uso Y Mantenimiento

39
All the packaging used around the machine can be recycled; The correct disposal of these products
will help to protect the environment. For further information regarding the recycling of these products,
please refer to the relevant office of the local body. Dispose of these materials in accordance with
current legislation.

5. USE AND MAINTENANCE INSTRUCTIONS

5.1 Operation

The steps required to optimise the operation of your dishwasher are shown below, with all the available
options.

5.1.1 Control panel symbols Fig. 9

A. Machine on/off button. (ON/OFF)
B. Short cycle button (90 s)/ Drainage button
C. Medium cycle button (120 s)
D. Long cycle button (180 s) / Cold rinse button

5.1.2 Switching on the machine

Before switching on the machine, check the following:
 The mains switch must be on.
 The water stop cock must be open.
 There must be water in the mains network.
 The corresponding filters must be in place.
 The overflow should be mounted in place.
To switch on the machine just press the ON-OFF button (A) once for 1.5 seconds.

5.1.3 Filling and heating

When the machine is switched on, it will start to fill. First the rinse boiler is filled and then the wash
tub. The filling process may last a few minutes. Once the wash tub is full, the boiler starts to heat up
and when it is hot, the tub is heated. Although it is possible to start the wash process, this is not
recommended as the water inside the machine is not yet at the ideal temperature. When the
machine has reached the ideal temperature for washing the dishes properly, the machine ready light
comes on.
The temperature in the boiler should be between 82-90 ºC and in the tank between 57-62 ºC
The manufacturer recommends that the water in the glass washer is changed every 40/50 washes or
twice a day.
The machine you have purchased has a safety thermostat in the boiler and another for the tub, so
that in the event of the breakdown of any of the main thermostats, the safety thermostats switch off
the corresponding heating.

5.1.4 Preparation of the dishes

Before washing the dishes, the preparatory steps below should be followed:




BEFORE STARTING THE APPLIANCE, PLEASE READ THE INSTRUCTIONS
THE APPLIANCE IS EXCLUSIVELY FOR PROFESSIONAL USE, AND SHOULD
ONLY BE USED BY QUALIFIED PERSONNEL.
E. Machine ready symbol
The door must be closed for the machine to start filling. For safety reasons, if the
door is open, the machine will not fill.
During the first heating of the day, the boiler may reach a higher temperature than
that mentioned above due to heating inertia. This is normal. If pressurised steam is
observed coming out of the rinse branch nozzles, while the boiler is heating, the
technical service should be notified.
Remove the largest pieces of waste from the dishes before placing them in the baskets.
Wash glassware first.
Put the plates in the rack basket.
Place the glasses upside down.
CONTAINED IN THIS MANUAL CAREFULLY.
F. Machine on pilot light
G. Machine working pilot
H. Machine working pilot
I. Machine working pilot
J. Machine ready pilot