General Specifications - Klein Tools LAN Scout Jr. 2 Manual De Instrucciones

ENGLISH

GENERAL SPECIFICATIONS

The Klein Tools LAN Scout™ Jr. 2 is a portable data cable tester. It tests and
troubleshoots RJ45 terminated cables and provides tone generation for
cable tracing.
Dimensions: 5.3" x 2.4" x 1.2" (13.5 x 6.1 x 3.0 cm)
•
Weight: 4.0 oz. (115 grams) with battery and remote
•
Operating temperature: 0°C to 50°C / 32°F to 122°F
•
Storage temperature: -20°C to 60°C / -4°F to 140°F
•
Humidity: 10% to 90%, non-condensing
•
Maximum Voltage between any two connector pins without damage:
•
RJ Jack: 66V DC or 55V AC
Battery Life typical: 2x AAA Alkaline batteries Standby: 3 years Active: 80 hours
•
Cable types: Shielded or Unshielded; Cat-7, Cat-6/6A, Cat-5E, Cat-3
•
Maximum Cable Length: 2000 feet (610 meters)
•
Minimum Cable Length for Split pair Detection: 1.5 feet (0.5 meters)
•
To ensure safe operation and service of the tester, follow these instructions.
Failure to observe these warnings can result in severe injury or death.
The LAN Scout™ Jr. 2 is designed for use on unenergized cabling systems.
•
Connecting the LAN Scout™ Jr. 2 to live AC power may damage it and pose a
safety hazard for the user.
Improperly terminated RJ plugs have the potential to damage the jacks on
•
the LAN Scout™ Jr. 2. Visually inspect an RJ plug before inserting it into the
tester. Plugging 6-position plugs into the 8-position jack on the tester has
the potential to damage the outer-most contacts of the jack unless the plug is
specifically designed for that purpose.
SYMBOLS ON TESTER
Warning or Caution
Always wear approved eye protection
Do NOT use on energized circuits
Read instructions
Conformité Européenne - Conforms with European
Economic Area directives
This symbol indicates that equipment and its
accessories shall be subject to a separate collection
and correct disposal
2
WARNINGS
TESTER PORTS, BUTTONS & DISPLAY
TESTER (FIG. 1 & FIG. 2)
FIG 1 - RJ45 shielded jack FIG 2 - Removable docked remote with Shielded
RJ45 jack
BUTTONS (FIG. 3)
A
Test Button performs wire map test on RJ45 terminated cable.
B
Tone Button transmits analog tones on conductor wires of RJ45 terminated
cables. Button also cycles through available tone cadences and conductor wire
selection options.
C
Power/Backlight Button turns unit on or off, turns backlight on or off.
FIG. 1
FIG. 2
FIG. 3
A
B
C
3