4.
MAIN – Press this button to view the Main screen in the display and software.
5.
PLAY – Press this button to play the Sequence from the audio pointer's current
position.
6.
PLAY START – Press this button to play the Sequence from its start point.
7.
STOP – Press this button to stop playback.
8.
REC – To start recording a Sequence, press this button and simultaneously
press PLAY or PLAY START. Recording in this way (rather than using
OVERDUB) erases the events of the current Sequence. After the Sequence
plays through once while recording, Overdub will be enabled.
9.
OVERDUB – Press this button and simultaneously press PLAY or PLAY START
to enable Overdub. This allows you to record note events in a Sequence without
overwriting any previously recorded note events. You can enable Overdub either
before or during recording.
10. UNDO – Press this button to undo your last action.
11. ERASE – As a Sequence is playing, hold this button down and press a pad to
delete the note event for that pad at the current playback position. This is a
quick way to delete note events from your Sequence without having to stop
playback.
12. PADS – Use these pads to trigger drum hits or other samples in your software.
The pads are velocity-sensitive and pressure-sensitive, which makes them very
responsive and intuitive to play. The pads will light up different colors,
depending on how hard you play them (ranging from yellow at a low velocity to
red at the highest velocity).
13. FULL LEVEL – Press this button to activate/deactivate Full Level. When
activated, the pads always play back at a maximum velocity (127), no matter
how hard or soft you hit them.
14. 16 LEVEL – Press this button to activate/deactivate 16 Level. When activated,
the last pad that was hit will be temporarily copied to all 16 pads. The pads will
now output the same note number as the initial pad, but a selectable parameter
will be fixed at the values shown in the diagram on the right, regardless of how
hard you hit them. The available parameters are velocity, tuning, filter, layer,
attack or decay.
15. NOTE REPEAT – Hold this button down and press a pad to retrigger that pad's
sample at a rate based on the current Tempo and Time Correct settings. Vary
the pressure on the pad to increase or decrease the velocity of the notes being
played.
16. TIMING CORRECT – Press this button to switch through the available Timing
Correct (quantization) settings.
17. TRACK UP / DOWN – Use these buttons to move to move to the next or
previous track.
18. MUTE TRACK – Press this button to mute the current track.
19. SOLO TRACK – Press this button to solo the current track.
5