Novoferm N-423 Manual Del Usario página 46

Installation
Menu 7:
Adjust the light phases
1. Select menu item "7".
After about 2 seconds the display blinks and the set value for light time appears.
The factory setting is "0".
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) buttons.
Menu value
0
1
2
3
4
5
6
7
8
9
Remarks:
- TAM (Door open message): 24 volts at door not closed.
- With set warning time light and 24 V for drive of control goes on.
3. Press the programming button (PROG button) (D). The display shows "8".
Menu 8:
Door adjustments
1. Select menu item "8".
After about 2 seconds the display blinks and the set value time appears.
The factory setting is "4"
This setting should be maintained. A change in the soft run routes may be made only with the express
permission of the door manufacturer.
2. If desired, adjust the setting with the aid of the OPEN (B) and CLOSE (C) buttons.
Menu value
0
1
2
3
4
5
6
7
8
9
Remarks:
- These values correspond to the soft run courses measured on carriages.
3. Press the programming button (PROG button) (D).
The display shows "9".
46
Light time
60 s
120 s
240 s
0 s
0 s
60 s
120 s
60 s
120 s
240 s
Start OPEN Stop OPEN
0
15
0
15
25
15
15
35
55
Warning time
0 s
0 s
0 s
0 s
3 s
3 s
3 s
0 s
0 s
0 s
Start CLOSE
0 0
0 15
15 0
15 15
30 25
15 15
15 15
35 65
15 15
only soft run
24 V
60 s
120 s
240 s
0 s
0 s
0 s
0 s
TAM
TAM
TAM
Stop CLOSE
0
0
40
35
40
55
15
45
100
N-423