Tabla de contenido
Idiomas disponibles
Idiomas disponibles
STEP 2: ASSEMBLING THE SUPPORT LEG
1.
Position the support leg so the J-shaped end is pointing away from the wheel
assembly.
2.
Insert the M8x75 hex bolt through the top hole on the support leg and slide
the spacer over the bolt end.
3.
Take the support leg and insert the bolt through the upper cross bar on the
mounting assembly and loosely tighten with the M8 lock nut.
NOTE: Before tightening the bolt make sure the support leg flange and the lower cross bar holes line up.
4.
Insert M6 x 40 hex bolt through the holes in the flange and cross bar. Use the
Ø6 big flat washer and M6 lock nut and tighten all hardware.
Frame Tube As-
sembly
Big Flat
Washer Ø6
Lock Nut M8
Lock Nut M6
Hex Bolt M6X40
Support Leg
Spacer
Hex Bolt M8X75
UK
7
Tabla de contenido
