Televes KITs SAT 650 Manual Del Usuario página 18

Reception
TV Satellite
CONNECTIONS
Fig. 17
Fig. 19
Connect the LNB and the receiver by using a T100 cable.
A SCART connector is used between the receiver and the TV.
Connect the unit to the mains. An LED lights up on the front of the receiver. This indicates that the unit is in
"STANDBY" mode.
NOTE: Before starting to use the receiver, we recommend that you read the user manual carefully.
HOW TO START TO USE THE UNIT
Read the receiver's user manual, and follow these steps:
Receiving the satellite
If you have carried out all these steps correctly, you should now be receiving Astra. If not or if the picture is blu-
rred, carry out a fine adjustment of the "b" angle (fig. 16) until you obtain a better picture. Afterwards, do the
same for the "a" angle (fig. 14).
Once the installation is complete, make sure that all the screws are tightly secured to avoid unwanted move-
ments which may cause you to lose the signal.
Fig. 18
LNB IN
DC13/17V
Select a program of the satellite that wishes to receive by pressing the
corresponding channel number on your remote control.
To do this, you can refer to the channel list at the end of the user manual.
18
650 / 800
LNB IN
DC13/17V
AUDIO
LNB IN
DC13/17V
VCR
DECODER TV L
R
AUDIO
DECODER VCR TV
L
R
KITS
230VAC~
50Hz/30W
230VAC~
50Hz/30W