Four Channel Remote Control Transmitter; Dual Rotor Blades' Speed Adjustment Via Pcb Control - Carson Agusta Westland Grand Manual De Instrucciones

c. Four Channel Remote Control Transmitter
Included in the scope of delivery is a remote control transmitter
with two remote control levers, which are assigned the two
respective functions.
These functions are activated by the movements forwards/
backwards and right/left.
AA X 8 batteries are required for
the transmitter (not included)
Trim lever pitch
Pitch (Lift)
Tail (Rudder)
Trim lever tail
Binding button
Functions on the back of the transmitter:
• Charging socket
• Battery chamber
Dual rotor blades' speed adjustment via PCB
control
Warning!!! Please work very carefully, applying minimal pressure and
using a small screw driver.
1. Function of button: adjust upper and lower rotor blades' different
speed.
a. Turning the button clockwise, upper rotor blade runs faster and
helicopter turns left.
b. Turning the button anti-clockwise, lower rotor blade runs
faster and helicopter turns right.
2. The "PCB CONTROL" is properly adjusted, when the helicopter no
longer drifts in any direction.
Put the charged batteries in the battery compartment of the
transmitter.
Pay attention to the correct polarity!
Antenna
1 Reverse switch for roll
Servo reverse switches to change the reaction direction.
Receiver plug
tail rotor function
Receiver plug
accelerator
CARSON Helicopter Agusta Westland Grand
Trim lever nick
Nick (Elevators)
Roll (Ailerons)
Trim lever roll
ON/OFF switch
4 Reverse switch for tail rotor
3 Reverse switch for acceleration
2 Reverse switch for nick
Adjusting screw
GB
29