Technical Data - Kiwi KPP 5402 Manual Del Uso

TECHNICAL DATA

USING ELECTRICAL APPLIANCE YOU MUST ACT IN COMPLIANCE
WITH THE FOLLOWING INSTRUCTIONS
• Read the instructions carefully before use. • Never touch the hot surface; only use the handles.
• To avoid an electrical shock, check the appliance regularly for damages to the appliance,
the cable or plug. If damages are found, do not use the appliance but bring it in for repair to
a qualified technician. • Take extra care in the presence of children; never leave the working
appliance with children without supervision. • Never immerge the appliance, cable or plug into
water or any other liquid. • Do not use any parts that are not delivered with the original pan;
this might cause danger. • Never place the appliance on or near a hot plate or any other heating
object, explosive or gas. • Never carry the appliance while still working: extra care must be taken
if the pan contains hot oil or fat. • Turn the regulator to the required temperature before you
plug in. • The appliance should only be used in domestic environment and for the use that it
has been designed for.
THESE INSTRUCTIONS MUST BE FOLLOWED. AUTOMATIC TEMPERATURE REGULATOR
THE RIGHT TEMPERATURE WILL BE KEPT AT THE SET TEMPERATURE OPERATION INSTRUCTIONS
RIGHT CONSTRUCTION: BEFORE USING CLEAN THE HEAT PLATE AND COVER COMPLETELY
1) PUT THE TEMPERATURE SCALE TO "OFF" POSITION AND PUT THE AUTOMATIC TEMPERATURE
REGULATOR IN THE INLET.
2) PUT THE PLUG INTO AN EARTHED 230V SOCKET
3) THE TEMPERATURE SCALE CAN BE SET IN ACCORDANCE
WITH THE FOOD; THE CONTROL LAMP IS ON TO SHOW THE
PAN IS HEATING.
COOKING
1) AFTER THE PAN HAS BEEN TURNED ON, WAIT 5-10 MINUTES,: AS SOON AS THE
CONTROLLAMP WILL LIGHT, YOU CAN START COOKING.
2) IF THE FOOD IS COMPLETELY DONE, THE TEMPERATURE CAN BE KEPT BY PUTTING THE
TEMPERATURE SCALE TO 'WARMKEEP'.
• If the lamp goes off, this is not an error, the automatic temperature regulator is in function.
• If there is some noise, this is not an error: the noise comes from the
heater and the heat plate
• Do not put your hand under the reflector; do not put any
inflammable material on the pizza pan.
3. After use
1) After use put the temperature scale to OFF
2) Pull the plug out of the socket, and then take out the automatic
temperature regulator from the heat plate
AC230V, 50Hz, 1500W
2