Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Care and Cleaning
WARNING: To reduce the risk of injury from accidental starting, unplug the power cord before emptying the dust tank.
1.
Remove the power head assembly of the wet/dry vacuum by pulling outward on the lid clips located on each side of the vacuum. Lift off
the power head assembly.
2.
Dump the tank contents into the proper waste disposal container.
Troubleshooting
WARNING: To reduce the risk of injury from moving parts and/or electrical shock, turn power switch off and disconnect power plug
from electrical outlet before performing troubleshooting checks.
Minor problems often can be fixed without calling customer service.
Problem
The vacuum does not run.
There is a loss of suction during wet
pick-up.
There is a loss of suction during dry
pick-up.
Possible Cause
No electricity.
□
The tank is full.
□
The hose is clogged.
□
The filter is clogged.
□
The tank is full.
□
The hose is clogged.
□
The filter is clogged.
8
Corrective Action
Make sure electrical outlet has voltage (a qualified
electrician may need to be contacted).
□
Drain and clean the tank.
□
Remove the hose and clean out the debris.
□
Clean or replace the filter.
□
Drain and clean the tank.
□
Remove the hose and clean out the debris.
□
Clean or replace the filter.
Tabla de contenido
